Hummer H2 2008 - Safety and Security; Remote Keyless Entry

. . . 6
DRIVER INFORMATION
FEATURE CUSTOMIZATION
To customize features:
1. The ignition must be on and the
vehicle must be in P (Park).
2. Press the button repeatedly
to scroll through the list of cus-
tomizable features available on
your vehicle.
3. With the desired menu item dis-
played, press to display the
item's submenu.
4. Press the button to scroll
through the available settings.
5. When the desired feature set-
ting is displayed, press the
button to select it.
6. Press
the button
to scroll to
the next customization feature.
To exit programming mode, do any
of the following:
•Turn off the ignition.
• Press the driver information cen-
ter trip/fuel information button
or vehicle information button.
• Press the customization but-
ton repeatedly until the follow-
ing message appears on the
display:
- EXIT FEATURE SETTINGS (exit
feature settings)
Press the button to exit the
menu.
DRIVER INFORMATION CENTER
MESSAGES
The Driver Information Center
provides a variety of vehicle warning
messages (depending on optional
equipment) if a problem is sensed in
a vehicle system.
Press to acknowledge a message
and remove it from the display.
Some messages may not be cleared
until the problem is fixed.
Note: Your vehicle’s warnings and
messages provide critical information
that can prevent damage to your
vehicle.
Clearing a message only makes the
message disappear. It does not elim-
inate the problem. Be sure to take
messages seriously.
08euH2ConGuide.fm Page 6 Wednesday, August 6, 2008 3:33 PM