Hummingbird APEX 19 - User Manual

1
532744-1_A
APEX™ SERIES CONTROL HEAD Installation Guide
Follow the instructions in this installation guide to gimbal mount the control head.
I P
Read the instructions in this transducer guide completely to understand the mounting guidelines
before starting the installation.
Visit our Web site at humminbird.com for additional information and resources for transducer
installations. Also, visit youtube.com/humminbirdtv for informational videos.
Supplies: In addition to the hardware supplied with your control head, you will need a powered
hand drill and various drill bits, flat head screwdriver, pencil, safety glasses and dust mask, marine-
grade silicone sealant, dielectric grease (optional), extension cables (optional), Ethernet cables
(optional), and accessory cables (optional). Also, see Connect Power to determine the type of
connection, fuse size, and additional equipment you will need for the installation.
Accessories and Ethernet: Accessories and Ethernet equipment are available for purchase at
humminbird.com. The installation guides are available with the product, or they can be downloaded
from our Web site.
I O
1
|
Plan the Mounting Location
Pre-assemble the control head to plan the best mounting location.
1. Place 1 metal washer onto each gimbal knob.
2. Place 1 rubber washer onto each gimbal knob.
3. Install the gimbal knobs (with washers) into each side of the control head. Tighten the knobs
just enough so you can slide the control head into the gimbal bracket arms.
4. Install the control head into the arms of the bracket mount. Confirm the opening in the gimbal
bracket arms faces the rear of the control head. Confirm the ratchets on the bracket and
control head fit together.
gimbal
knob
bracket arm opening
rubber
washer
metal
washer
Assembling the Control Head and Bracket
If you prefer to mount the control head overhead, flip the bracket to the top of the control
head. The opening in the gimbal bracket arms must face the rear of the control head.
NOTE: Overhead and/or thin panels may require additional hardware (separate purchase
required) to securely mount the control head.
5. Hand-tighten the gimbal knobs to secure the control head to the gimbal bracket.
back of bracket
Overhead Mount

Hummingbird APEX 19 Specifications

General

Brand	Hummingbird
Model	APEX 19
Category	Controller
Language	English

Summary

INSTALLATION OVERVIEW

1 Plan the Mounting Location

Pre-assemble the control head to plan the best mounting location.

2 Install the Gimbal Bracket

Traditional Mount

Instructions for mounting the gimbal bracket using the traditional method.

3 Connect Power

Cable Length

Information on extending the power cable length using appropriate wire gauge.

Power Supply

Guidance on connecting to a 12 VDC power supply and required fuse sizes.

Fuse Panel or Battery

Options for connecting the power cable to a fuse panel or directly to the battery.

4 Route the Cables to the Control Head

Sonar

Proceed to the transducer installation guide for sonar cable routing.

Accessories (optional)

Install accessories using the guides provided with them.

Ethernet (optional)

Install Ethernet cables and hardware using the Ethernet Installation Guide.

Routing the Cables Behind the Bracket

Instructions for routing cables behind the mounting bracket for a clean installation.

5 Test the System Installation

Start Normal Mode

Turn on the control head and select Start Normal Mode for initial setup.

Begin Manual Setup

Select manual setup to configure the unit, with options for importing settings.

Angler mode; Custom mode

Configure the unit using Angler mode (smart defaults) or Custom mode (detailed customization).

GPS; Accessories

Confirm GPS status and that accessories are listed as connected.

Sonar Test

Test and finalize the transducer installation according to its guide.