2
Attitude
Installation Manual
®
(a)
DO NOT USE WALL CONTROLLERS. Other than a simple On/Off switch
(b)
The power outlet must provide an earth.
(c)
Mounting bracket must be firmly screwed to a solid structure such as a concrete ceiling,
steel structure or timber framing. If additional bracing is added it must be firmly secured to
the rafters and not left floating on the ceiling. Special mounts, such as T-hooks, are
available for certain types of installation.
(d)
After installation, fan blades must be at least 2.1 m (7 feet) above floor level.
(e)
The use of these products by children and the infirm must be under supervision.
IMPORTANT INFORMATION READ PRIOR TO INSTALLATION
1. Installer details and purchase receipts are essential for warranty claims and must be available
upon demand. A page towards the back of this manual has been allocated to allow you to record
these details.
2. Power outlets, switches and fixed wiring products must only be installed by persons who are ap-
propriately licensed by the applicable State regulatory body. Therefore, to protect our repair per-
sonnel, on-site warranty claims will not be accepted if power outlets or fixed wiring has been per-
formed by unlicensed persons.
3.
Damage caused by incorrect installation, force-majeure, electrical surges, lightning, power grid
fluctuations, water or by connection to stand alone alternative power supply sources (such as
non-grid solar inverters, etc.) is not eligible for warranty repair.
4.
When products are installed in a location requiring special access equipment (such as
scaffolding or scissor lifts, etc) the cost of providing, installing and operating special access
equipment must be borne by the site owner.
For safety, and to protect your warranty, the following must be taken into account when
installing and operating the product(s):
ATTENTION ELECTRICIANS:
This product must be installed using an ON/OFF wall switch to aid in Control Module
programming and troubleshooting. If it is not possible to use a wall switch then the
Control Module and Handsets must be checked before installation. To do so connect
the Control Module to a standard GPO and verify the Control Module beeps when
buttons are pressed on the hand piece. If not program the unit as per page 17.
IF THERE ARE ANY PROBLEMS WITH THE PRODUCT AT TIME OF
INSTALLATION THE INSTALLER MUST CONTACT THE WARRANTY
HOT LINE NUMBER
1300 360 280
.
BEFORE LEAVING THE JOB
SITE. PLEASE DO NOT REMOVE THE FAN FROM THE CEILING
ONCE INSTALLED UNLESS INSTRUCTED TO DO SO.
To Next Page
