7
2. All the functions performed using the remote control work
identically to the buttons on the control panel, except that there
is no
only can use the and buttons to switch the desired
temperature you want. You cannot change the display to show
the temperature reading between Celsius and Fahrenheit by
pressing and buttons.
Note: Change the batteries with new ones if the remote control
does not operate well. Otherwise your remote control may not
operate properly. Remove the batteries out of the remote control if
you won't use the remote control for a long time. Remaining
batteries may damage your remote control.
Note: Do not mix old and new batteries. Do not mix alkaline,
standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
Battery Disposal - Please dispose of the used battery per
municipal or provincial law.
Figure 11
Remote Control (Figure 11)
1. The remote control uses two (2) "AAA" batteries (not included)
for operation.
4. Once the room temperature reaches 2 degrees above the set
temperature, the heater will shut off. Once the room temperature
reaches 2 degrees below the set temperature, the heater will turn
back on and continue to cycle off and on to maintain the set
temperature.
5. This function will cancel if the button is pressed and the
heater will run continuously.
NOTE:
The temperature display does not indicate the temperature
NOTE:
It is normal for the heater "fan" to run for approximately 30
of the heated air being emitted by the heater.
You also can press the or buttons on the remote control to
set the room at desired temperature.
seconds when the heater shuts off after reaching the set
temperature.
81614-01 R20200301
Temperature Setting Button
on remote control; you
2. Press the and buttons at the same time for two seconds
to change the display to show the temperature reading in Celsius.
Press the same two buttons together again to change the display
back to show the temperature reading in Fahrenheit.
3. When the display shows the temperature at which you want to
set the unit, the set temperature will flash several time. The
display will return to indicate the current room temperature and
will gradually change as the room temperature changes.
1. To set the room at a specific temperature, press the
Temperature Setting Button
, then press the or
buttons to the desired temperature. The heater is now in Auto
Temperature Mode and the indicator will glow on the
.
A
LED
display
Figure 9
Figure 10
Automatic Temperature Control (Figure 9) (Figure 10)
To Next Page
Loading...