Hunter Omega - Menu; Cam Mode; Image Size; Multi-shot Video Size

Menu
Slide the “Power Switch” to SETUP position and press “MENU” once to
enter camera setting menu. Navigate the setting interface by pressing
“◄”, “▲”, “►” or “▼”, press “OK” for selection or “MENU” to exit to
previous page.
Note!
● For some settings, user needs to press “MENU” to save & exit the
configuration after pressing “OK” to confirm (Cam ID, Delay, Time Lapse,
Timer, Password).
● In other settings pressing “MENU” switches alpha/ digits/ symbols.
Cam
Setting
Programmable Options
Cam Mode
Photo – camera shoots photos only, based on
configured Multi-shot & Image Size.
Video – camera shoots videoclips only, based on
configured Video Size.
PIC+Video – camera shoots photo(s) first, then video
upon same trigger event, based on configured Multi-
shot, Image Size and Video Size.
Image Size
24MP (5632x4224),
12MP (4032x3024),
8MP (3264x2448),
stored on the SD Card
Multi-shot
Programmable 1~5 photos per trigger.
Video Size
FHD (1920x1080) – 10sec.
HD (1280x720) – 10sec.
WVGA (848x480) – 10sec.
Night Mode
Min.Blur – Short exposure time to minimize motion blur
for better image quality; shortened IR flash range.
Max.Range – Longer exposure time to extend IR flash
range for better night vision; lower image quality.
Balanced – Combination of above 2 options.
Flash Power
High – Stronger flash in dark environment. All 57 IR
LEDs will work (consume more battery current).
Low – Weaker flash in dark environment. Bottom 30 IR
LEDs will be turned off (consume less battery current).
Cam ID
Select “ON”, press “OK” to set 12 digits/ alphabets for