Hunter Permalife 30748 - Page 12

41555-011 12
Air Purier Maintenance
FILTER
3. Gently pull on the lter to remove it from the unit. While removing the lter,
note the directional arrows printed on the top of the lter. The lter will be
reinstalled with the same orientation. Refer to Fig. 10.
4. The label on the top side of the lter points to the side that should be cleaned.
Refer to Fig. 10. With a vacuum cleaner and upholstery brush attachment,
clean the lter until all particles are removed. Do not use water or liquids to
clean.
5. Install the lter with arrows pointing towards the unit. Refer to Fig. 10. Press
the lter rmly into the air purier. To avoid damaging the lter media, you
should press on the frame of the lter only.
6. Place the front grill back onto the unit. First, line up the tab on the bottom
of the grill with the recess on the purier base and then push the top of the
grill forward until it is closed. Refer to Figs. 6 and 7 (pg. 7). NOTE: This unit
will not operate unless the grill is in the correct position.
7. Plug in the unit.
8. To reset the lter counter, press the FILTER RESET key for 2 seconds. The Filter
Counter will return to 100% and the Filter indicator will stop ashing.
Fig. 10