Fig. 4
Fig. 5
Fig. 6
Fig. 7
HANDLE
PULL
FORWARD,
THEN UP
TAB
RECESS
LINE UP TAB WITH
RECESS IN BASE
Fig. 8
OFF SLEEP ACTIVE TURBO
Initial Operation
This section provides basic instructions on the use of your air purier. After following
these initial directions, please continue reading this booklet to learn how to operate
the more advanced features of your air purier.
Basic Operation of the Air Purier:
1. Take the air purier out of the box and remove the clear plastic protective
bag. Place the unit on a rm level oor.
2. Before turning on the air purier, you need to conrm that the lters are
rmly in place and have not become loose during shipping. To check the
lters, rst open the front grill. Release the front grill by placing your ngers
under the handle on the grill and pull forward, then up. Refer to Figs. 4 and
5.
3. Next, check the cleanable lter by pressing rmly on all four corners of the
lter to ensure that it is fully inserted into the lter opening.
4. The carbon pre-lter is mounted inside the front grill with hook tape. Conrm
that it properly covers the grill vents. You may notice a few black particles
coming off the pre-lter. Those particles are part of the odor-removing
activated carbon and will be collected on the lter during use.
5. Place the front grill back onto the unit. First, line up the tab on the bottom
of the grill with the recess on the purier base and then push the top of the
grill forward until it is closed. Refer to Figs. 6 and 7. NOTE: This unit will
not operate unless the grill is in the correct position.
6. Plug the unit into a 120V electrical outlet and press the OFF/SPEED key.
The air purier will start with a low blower speed.
7. Use the OFF/SPEED and TURBO keys to adjust the blower speed to the
desired level (Off, Sleep, Active, Turbo Clean). Refer to Fig. 8.
8. Use the TURBO key to adjust the blower speed to high. After 1
1
⁄2 hours,
the fan will return to the previous speed setting.
To Next Page
Loading...
