3
8. Position the base near the intended location. Refer to “Placement,” on page 1 for detailed instructions.
IF APPLICABLE, REMOVE THE SHIPPING BOLT FROM THE VIBRATION STRUCTURE
1. Locate the shipping bolt, identified by the yellow tag, on the front of the balancer.
REMOVE
Figure 3
2. Remove and discard the shipping bolt.
REMOVE WEIGHT TRAY
1. Remove the two flat head socket cap screws that secure the weight anvil to the weight tray.
The inner Dataset® arm does not need to be removed for weight tray removal.
Figure 4
To Next Page
Loading...
