Hunter Road Force Touch GSP9700 Series - Initial Balancer Power-Up; Power Up Balancer and Connect Air

40
3. If necessary, adjust belt tension with 1/2-inch drive racket as follows:
• Loosen four motor mount bolts.
• Position a 1/2 inch drive ratchet into the square hole in the adjusting cam.
• Increase belt tension by pulling the ratchet in a clockwise rotation.
• Tighten four motor mount bolts.
• Re-check belt tension and adjust as needed.
ADJUSTING
CAM
MOTOR MOUNT
BOLT
MOTOR MOUNT
BOLT
Figure 72
• Position spindle drive belt cover to housing assembly and secure using four screws previously removed.
4. Verify that the inner Dataset arm returns to the home position. If it does not, remove weight tray and correct.
TURN “ON” THE BALANCER
1. Verify that the power switch at the back of the balancer is in the off position. Plug the power cord into a
230VAC +10% / -15%, 50/60 Hz single-phase electrical outlet of a 20 Amp branch circuit.
2. Connect air supply hose to the shop’s 100-175 psi (6.9–12.0 bar) air supply line.