5
4. Remove rust-preventative paper from within balancer tub. During assembly of balancer, route all external
wires and air lines (if present) through the hole located in back of balancer.
Figure 7
INSTALL DISPLAY SUPPORT ASSEMBLY AND LCD MONITOR
1. Remove support from plastic and align on back left corner. Loosely secure the display support to the base
assembly with four 1/4-20 X 1/2 inch socket button head cap screws, located in accessories kit. Two screws
fasten through the rear of the base assembly and the other two fasten through the side.
Figure 8
2. Incrementally tighten the four screws together to attach the display support to the outside corner of the
balancer.
To Next Page
Loading...
