53
11. Reinstall the Socket head cap screw (74-107-2) previously removed through the beam and secure with the
nut previously removed.
CARRIER
STOP
Figure 91
For the carrier stop bolt to work properly, installed the nut on the backside of the beam
(as shown).
12. With the wheel lift in the down position, roll an average size tire/wheel assembly onto the carrier.
13. Lift the lift control handle “up” to move the wheel lift into position to slide the tire/wheel assembly onto the
spindle. Verify that the tire/wheel assembly is centered vertically on the spindle.
SPINDLE
TIRE/WHEEL ASSEMBLY
CENTERED VERTICALLYON
THE SPINDLE
Figure 92
To Next Page
Loading...
