3
4
Ceiling Bracket Downrod Hanging Fan Wiring CanopyBlades Cap TroubleshootingRemote
Check the outlet box:
Installing the Ceiling Bracket
Installing the Blade Assembly
Use wood screws and
washers (included) when
securing to support structure
with approved electrical
outlet box. Drill 9/64” pilot
holes in support structure
to aid in securing ceiling
bracket with hardware found
in the hardware bag.
Use machine screws
(provided with outlet box)
and washers when securing
to existing ceiling fan-rated
outlet box. Make sure it is
securely installed and is
acceptable for fan support of
31.8 kg (70 lbs) or less.
Option 2:
Wood Screws
Option 1:
Machine Screws
OFF
Turn Power
Do this rst!
The machine screws are the ones
that came with your outlet box.
Hunter Pro Tip:
For angled ceilings,
point opening
toward peak.
ANGLED
MOUNTING TIP
bag
Wood Screw
Washer
x2
x2
You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan’s box.
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
Overlap the two blades.Lower the blades onto the top of the blade ring as shown. Align the screw
holes in the blade ring with the screw holes in the blades. Install the blade assembly screws,
found in the hardware bag , into the blade ring as shown. Hand tighten the screws.
6 of 11
bag
Blade Screw
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.
Repeat x2
To Next Page
Loading...
