EasyManuals Logo

HunterDouglas PowerView Hub 2.0 User Manual

HunterDouglas PowerView Hub 2.0
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
Test signal to Repeater(s).
Press and hold the P button on the back of the PowerView® Hub. The
light on each Repeater should blink BLUE. If the Repeater does not blink
BLUE, move the Repeater closer to the Hub or pair the Repeater to the
correct PowerView® Shade Network.
Other controls on the back of the Hub include the R button which
power cycles the Hub and erases all Hub data when pressed and held
for 6 seconds.
Transfer your hub data (if needed).
If you have a Gen 1 Hub (above left) on your PowerView® Shade
Network, follow in app instructions to transfer Hub data to the new
PowerView® Hub.
9

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HunterDouglas PowerView Hub 2.0 and is the answer not in the manual?

HunterDouglas PowerView Hub 2.0 Specifications

General IconGeneral
BrandHunterDouglas
ModelPowerView Hub 2.0
CategorySwitch
LanguageEnglish

Related product manuals