1-
7
or outside the instrument or disconnection of the protective
ground terminal is likely to make the instrument dangerous. Intentional
interruption is prohibited.
Do Not Operate Without Covers. Do not operate this instrument with covers or panels removed.
Use Proper Fuse. Use only the fuse type and rating specified for this instrument. (see “Fuse
Replacement” below)
Avoid Exposed Circuitry. Do not touch exposed connections and components when power is
present.
Do Not Operate With Suspected Failures. If you suspect there is damage to this instrument,
have it inspected by qualified service personnel.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
Fuse Replacement:
Line Fuse tray
The power entry module on the Tracker 2700 includes the power switch (0 = OFF, 1 = ON),
power cord connector, and a removable tray which holds the line fuse.
Figure 1-1. Power Entry Module with Fuse Tray.
Make sure that replacement fuse is of the type and current rating specified. If necessary, insert
the specified line fuse (T400mA according to IEC 127) into the fuse tray.
To Next Page
Loading...
