HURST 3910201 - Tools Required for Installation; Essential Tools List; Shifter Installation Steps; Initial Shifter and Boot Removal

12 pages

To Next Page

To Previous Page

TOOLS



TechnicalSupport(707)544‐4761    2     www.HURST‐SHIFTERS.com



Flat Blade

Screwdriver

Plastic Trim

Tool

Extension

7/32” Hex

Wrench

Ratchet

10mm,13mm,

9/16”Wrench

10mm Deep

Socket

Cutting Pliers

Floor Jack

Jack Stands

STEP 1. Move the shift knob to the Neutral

position. (Set the parking brake to ensure that the

vehicle does not move during installation).

2005-2009: Work the upper part of the shift boot

out of the retainer groove of the shift knob and

slide down onto stick.

2005-2010: Remove the knob by turning counter

clockwise.

STEP 2. Remove the shifter boot.

2005-2009: Place fingers or Trim Tool underneath

outer corners of the shifter boot and pull up to

unsnap from the center console. Slide boot up and

over the shift stick and place the boot aside. Skip

to STEP 5.

TOOL: Plastic Trim Tool

2010: See STEP 3.