HURST 3910201 User Manual



WORK SAFELY! For maximum safety, perform this installation on a clean, level surface and with the
engine turned off. Place blocks or wedges in front of and behind both rear wheels to prevent
movement in either direction.
CAUTION: To avoid any possibility of bodily injury or damage to vehicle, do not attempt installation
until you are confident that the vehicle is safely secured and will not move.
NOTE: FOR PHOTOGRAPHIC PURPOSES, A 2010 MUSTANG IS SHOWN THROUGHOUT
THESE INSTRUCTIONS. 2005-2009 GT KITS INSTALL WITH IDENTICAL STEPS.
PARTS








TechnicalSupport(707)544‐4761    1     www.HURST‐SHIFTERS.com
Installation Instructions
HURST COMPETITION AND BILLET/PLUS SHIFTER
2005-2010 Mustang w/5-speed Manual Transmission (GT only)
Catalog# 3910201
Knob
Hurst Stick
Shifter (3915201 shown)
Knob Nut
Stick Mounting
Screws (2)
Stick Mounting
Washers
(
2
)
Neoprene
Isolators (2)
Boot Support and Zip Tie

HURST 3910201 Specifications

General

Brand	HURST
Model	3910201
Category	Microphone system
Language	English

Summary

Parts Identification

Included Components

Lists all components included in the Hurst shifter kit for installation.

Tools Required for Installation

Essential Tools List

Details all necessary tools required for performing the shifter installation procedure.

Shifter Installation Steps

Initial Shifter and Boot Removal

Steps for removing the shift knob and shifter boot, with model-specific instructions.

Center Console Disassembly (2010 Mustangs)

Procedure for removing the center console and disconnecting electrical harnesses.

Stock Shifter Assembly Removal

Detailed steps for detaching the stock shifter linkage rod and mounting hardware.

Shifter Bracket and Bushing Removal

Instructions for removing the metal bracket from the rear mount and shifter bushings.

Hurst Shifter Preparation and Installation

Steps for preparing the Hurst shifter and inserting it through the floor tunnel.

Shifter Assembly Mounting and Linkage Connection

Securing the Hurst shifter to the transmission and connecting the linkage rod.

Shifter Stick Assembly and Boot Reinstallation

Assembling the shifter stick, optional isolators, and reinstalling the rubber boot.

Boot Support and Console Reassembly (2010)

Attaching the boot support and preparing the boot for 2010 models.

Final Console and Boot Reassembly

Completing the center console and boot reassembly for 2010 Mustang models.

Shifter Knob and Nut Installation

Final steps for attaching and orienting the shifter knob and securing the knob nut.

Technical Service and Support

Contact Information

Provides contact details for technical support, correspondence, and warranty questions.