TechnicalSupport(707)544‐4761 11 www.HURST‐SHIFTERS.com
STEP 31. Attach the Knob Nut onto the HURST
stick and thread down as far as possible without
forcing it.
STEP 32. Screw on the HURST knob all the
way down until it contacts the knob nut, then
back it off until the orientation of the shift
pattern/logo is correct.
STEP 33. With one hand holding the knob in the
correct orientation, use the other hand to tighten
the knob nut up against the knob.
TOOL: 9/16” Wrench
STEP 34. Congratulations. You have now
installed HURST’s short throw shifter in your
Mustang.
To Next Page
Loading...