TechnicalSupport(707)544‐4761 10 www.HURST‐SHIFTERS.com
STEP 27. 2010 MUSTANGS ONLY:
Place the upper center console loosely over the
lower center console. Arrange the upper center
console in a way that will give you some working
room between both consoles. Slide the boot over
the HURST chrome stick.
STEP 28. 2010 MUSTANGS ONLY:
Work the boot over the rubber boot support.
Make sure the boot material is properly
orientated and attach a zip tie around the boot
material. Make sure the zip tie is in the groove of
the rubber boot support and tighten. Cut off the
excess zip tie material.
TOOL: Cutting pliers
STEP 29. 2010 MUSTANGS ONLY:
Reconnect the ESC/Hazard/Trunk Release
harness that was disconnected in STEP 4.
STEP 30. 2010 MUSTANGS ONLY:
Replace upper center console to lower center
console by snapping into place.
To Next Page
Loading...