7
en
es
fr
pt
Repairs may only be performed by a trained service technician�
Only genuine HURST accessories and spare parts may be
used�
Please note that when working with the equipment, material
could fall down or suddenly break free as a result of shearing,
tearing or breaking�
Observe all intervals for recurring tests and inspections
as de- as de-
scribed in the chapter “Maintenance and care”� scribed in the chapter “Maintenance and care”�
The eDRAULIC devices and batteries are not suitable for under-The eDRAULIC devices and batteries are not suitable for under-
water use� water use�
Swallowing or inhaling the vapor of hydraulic uid can be det-
rimental to health� Avoid direct skin contact� Please note that
handling hydraulic uid can negatively aect biological systems.
Moving safety bolts, e�g� for removeable tips, must always be
fully inserted and locked�
When using chain sets, make sure that the chains are attached
in a straight line and that there are no knots in the chain�
When working near live components, high voltage ashovers
and the passage of current to the device are to be avoided�
Prevent the electrostatic charging of the device�
HURST eDRAULIC devices are not explosion-protected! Using
these devices in explosion-protected areas is forbidden�
Please ensure that you do not become entangled in cables and
trip when working with or transporting the device�
Ensure adequate lighting at the location of use and on the way
there�
The battery housing must not be damaged or subjected to me-
chanical stresses, as this may damage the cells inside�
Avoid deep discharge of the battery�
Prevent conductive materials such as water, oil or metallic ob-
jects from short-circuiting the terminals�
Always allow wet batteries to dry before inserting into the charger�
To Next Page
Loading...
