Huskie Tools HH100 - User Manual

Questions and Answers

T
terri15Aug 11, 2025
Why Huskie Tools HH100 Power Hammer does not run?
- V
  vholmesAug 12, 2025
  Your Huskie Tools Power Hammer might not be running due to several reasons. It could be that the couplers are not securely connected; in this case, connect them securely. Another cause could be an incorrectly set relief valve, which requires adjusting the main and secondary relief valve. Other potential issues include a malfunction of the hydraulic pump (repair the pump), excessively high nitrogen gas pressure (adjust the gas pressure), a damaged main valve (replace the main valve), or a damaged piston (repair or replace the piston).
B
Brittany BaileyAug 19, 2025
What to do if Huskie Tools HH100 has hesitation or erratic operation?
- H
  hknoxAug 19, 2025
  If your Huskie Tools Power Hammer is showing hesitation or erratic operation, several factors could be responsible. Start by checking if the couplers are fully engaged and connect them securely if they are not. Also, verify the relief valve setting and adjust the main and secondary relief valve if necessary. A malfunctioning hydraulic pump could also be the cause, requiring a pump repair. High oil temperature (exceeding 180°F or 80°C) can lead to this issue, so check the oil cooler. Other potential reasons include a damaged main valve (replace the damaged main valve), decreased oil flow (avoid simultaneous axis movement), auto shut-off during operation (apply proper down force), excessive bushing wear (replace worn bushings), or a damaged piston (repair or replace piston).
D
Deborah PughAug 26, 2025
Why Huskie Tools Power Hammer has low impact power?
- J
  joannacrawfordAug 26, 2025
  If your Huskie Tools Power Hammer exhibits low impact power, possible causes include low nitrogen gas pressure, which can be resolved by adjusting the gas pressure. An incorrectly set relief valve may also be the reason; in this case, adjust the main and secondary relief valve. Another potential cause is a malfunctioning hydraulic pump, which would require repairing the pump.
B
barbarasmithSep 2, 2025
How to fix slow impact speed of Huskie Tools Power Hammer?
- D
  dustin67Sep 2, 2025
  If you are experiencing a slow impact speed with your Huskie Tools Power Hammer, there are several potential causes. The nitrogen pressure might be too high, requiring an adjustment of the gas pressure. Another possibility is hydraulic oil leakage into the gas chamber, which can be fixed by replacing the seal kit. A malfunction of the hydraulic pump could also be the cause, necessitating a pump repair. Finally, deteriorated or contaminated oil can lead to this issue, so consider changing the oil.