All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support /
Product Updates. 2021 Keystone Automotive Operations Inc. All Rights Reserved. 05/04/2021-Rev12
Page-15
23.Once the spring bar is resting securely on the lift bracket insert the “L” retaining pin into the
square hole and secure with the hair pin clip.
WARNING: Keep clear of the pivot path of all moving parts when there is tension on the spring
bar. Maintain control of the lift handle at all times when raising or lowering the spring bar. Be sure
that the “L” pin and hair pin is in place before driving.
Check Vehicle Height and Adjust
Spring Bars If Necessary
24. Retract the tongue jack completely so the hitch is supporting the weight of the trailer.
Measure the same 3 places as done on pages 5 & 6 and compare. The tow vehicle should
settle evenly front to back. The rear fender should not settle lower than the front fender, if it
has then you will need to either raise the lift brackets 1 hole or add a hardened washer under
the large head tilt pin on the head assembly. The frame mark should be ¼”-1” max higher
than the original measurement noted on page 5, section 3.
To Next Page
