Husky 32858 User Manual

Use with 10 bolt 30686 base rails ONLY. Base Rails are not included with this kit.
Center Bolt Kit 32059 (sold separately) must be used when towing with a
26K hitch, Goose Neck, or Maneuvering System.
Parts Diagram
Figure: 1
20
TOOLS
3/16" drill
17/32" drill
21/32” drill
1-5/16” drill
1/2" Socket & Open End Wrench
5/8” Socket & Open End Wrench
Torque Wrench
"C" Clamps
Hardware Torque Values:
1/2” to 75 lb-ft
5/8” to 150 lb-ft
Caution: You must remove backing paper on rubber insulator pads to properly install. Once backing paper is
removed and the rubber pads are installed; it is PERMANENT and cannot be removed. ONLY Install on the
brackets and base rails. DO NOT install rubber insulator pads on the truck bed.
Do NOT use with base rail # 31323.
Dealer /
Installer:
Provide a copy of these Instructions to the end user of this product. These Instructions provide important
operating and safety information for proper usage of this product. Demonstrate the proper use of the
product with the end user. Have the end user demonstrate that they understand the proper use of the
product.
End User:
Read and follow all instructions included in this manual. Ask your Dealer / Installer for assistance if you do
not understand the proper use of the product. Never remove any decals from the product.
WARNING! Never exceed the
towing capacity of the tow vehicle.
Ford F150 4 Bolt Custom
Installation Bracket Kit.
Assembly, Installation, Operation and
Maintenance Instructions
P/N: 32858

Husky 32858 Specifications

General

Brand	Husky
Model	32858
Category	Automobile Accessories
Language	English

Summary

Installation Components and Specifications

Parts Diagram

Visual representation of all included parts for the installation.

Required Tools

List of tools necessary for performing the installation procedure.

Hardware Torque Values

Specified torque settings for various hardware components during installation.

Preparation and Safety Guidelines

Vehicle Preparation and Safety Warnings

Instructions on preparing the vehicle and critical safety precautions before installation.

General Installation Cautions and Notes

Important guidelines regarding installation procedures, vehicle compatibility, and material handling.

Bracket and Rail Mounting Procedure

Drilling Location and Preparation

Identifying and drilling specific holes on the vehicle frame for bracket mounting.

Frame Bracket Installation

Steps for installing front and rear frame brackets onto the vehicle chassis.

Securing Frame Brackets with Hardware

Detailed instructions on using pull wires, bolts, washers, and nuts to secure brackets.

Insulator and Spacer Placement

Applying rubber insulators and spacer tubes between brackets and the truck bed.

Base Rail Alignment and Attachment

Procedures for aligning and temporarily securing the base rails to the vehicle.

Final Assembly and Warranty

Final Torque and Reassembly

Tightening all hardware to specified torque and reinstalling removed vehicle components.

Warranty Terms

Details of the 5-year limited warranty for the installation bracket kit.