Husky H4470 - Installation and Connection; Air Hose Cleaning Procedure; Connecting to Air Supply

5 HUSKYTOOLS.COM
Please contact 1-888-43-HUSKY for further assistance.
Installation
1
Cleaning the air hose
□ A 3/8 in. air hose is required, with a maximum length of
25 ft.
□ Clean the air hose of accumulated dust and moisture
before connecting it to the air supply.
NOTE: If a longer air hose is required, connect a 1/2 in. air
hose to the 3/8 in. air hose to ensure the air saw has the
necessary air supply.
2
Connecting to the air supply
□ Always use clean dry air. Excessive moisture and dirt will
greatly reduce the life of any air motor. We recommend the
installation of an in-line filter-regulator-lubricator as close
to the tool as possible.
□ Ensure all hoses and fittings are the correct size and
secured tightly.
Recommended Air Line Set-Up
Ref. Description
1 Impact Wrench
2 Quick Plug
3 Quick Coupler
4 Air Hose
5 In-line Regulator
6 In-line Lubricator
7 In-line Filter
8 Air Compressor