5
Installation
1
Cleaning the air hose
□ A 1/2” air hose is required, with a maximum length of 25 ft.
□ Clean the air hose of accumulated dust and moisture
before connecting it to the air supply.
NOTE: If a longer air hose is required, connect a 3/4"
air hose to the 1/2" air hose to ensure the tool has the
necessary air supply.
2
Connecting to the air supply
□ Always use clean dry air. Excessive moisture and dirt will
greatly reduce the life of any air motor. We recommend the
installation of an in-line lter-regulator-lubricator as close
to the tool as possible.
□ Ensure all hoses and ttings are the correct size and
secured tightly.
Recommended Air Line Set-Up
Part Description
A 3/4” Impact Wrench
B Quick Plug
C Quick Coupler
D Air Hose
E In-line Regulator
F In-line Lubricator
G In-line Filter
H Air Compressor
To Next Page
Loading...
