All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. See www.huskytow.com for Warranty Information /
Tech Support / Product Updates. ©2020 Keystone Automotive Operations Inc. All Rights Reserved. August. 2020. Page-3
1. The following instructions should be used to install the
underbed gooseneck hitch. Care and attention to detail
will ensure a quick and quality installation. Check parts
against parts list to become familiar with parts in kit.
2. Raise rear of truck high enough to allow jack stands to
be placed under rear axle tubes of truck axle on each
side. This will provide maximum room to install the
underbed gooseneck hitch.
3. Once truck is safely lifted, remove the spare tire, the spare tire heat shield, and most rearward portion of the
exhaust system. In doing so, you will increase the space available to work. Note: Spray lubricant will help to
remove exhaust hanger bushings. Use caution when working around hot exhaust systems.
4. Slide one nut plate (#2) in from the bottom of the truck to on top of the crossmember. Align the nut plates (#2)
bolt holes from bottom of truck with holes in the factory crossmember. (See Figure 2). Note: Before the nut
plate (#2) install, run flanged head bolts (#8) into nut plates (#2) to ensure clean threading.
CAUTION:
These instructions are guidelines only. Actual installation is the responsibility of the installer and the
owner. Always measure truck and trailer before installing hitch to be sure that there is clearance at the
cab and at the bumper to allow for turns.
5. Using the included bed drill guide (#9), install center section (#1) and mark center with a paint pen from the
bottom of the truck. After center point is marked, remove center section (#1) and drill through the bottom with a
3/16” drill bit. It is important to square the center section (#1) to the crossmember to ensure accuracy of
the pilot hole location. Once pilot hole is drilled, finish drilling through truck bed floor from the top side using a
3-1/4” diameter hole saw.
6. Once 3-1/4” diameter hole is drilled, remove excess metal from bed and discard bed drill guide (#9). Note: All
sharp edges should be filed smooth and bare metal should be sprayed with a rust inhibitor to reduce
the spread of rust.
WARNING:
ONLY USE HARDWARE SUPPLIED WITH THIS
UNDERBED GOOSENECK HITCH KIT. ALL NUTS AND
BOLTS ARE GRADE 8 UNLESS OTHERWISE
SPECIFIED ON THE PARTS LIST.
WARNING:
If the truck is raised, be sure that the truck is properly
blocked and restrained to prevent the truck from
falling. Failure to do so may result in the truck
suddenly falling, causing death or serious injury.
TOOLS NEEDED FOR INSTALL
Paint Pen
Safety Glasses
Hearing Protection
Hand Drill
3/16“ & 21/32“ drill bits
3-1/4” metal hole saw
½” Drive Ratchet, 24mm socket, & 24mm wrench
Torque Wrench capable of 250 ft.-lb.
Rust Inhibitor Spray
Metal Hand File
CAUTION:
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines,
structural members, etc. HUSKY TOWING PRODUCTS does its best to communicate tow vehicle
manufacturer changes; however, it is ultimately the responsibility of the installer to prevent damage due
to installation.
To Next Page
Loading...
