HUSLOG BE-430334 - Troubleshooting and Cleaning; Troubleshooting Common Issues; Device Cleaning Procedures

EN © 2023 HUSLOG All Rights Reserved Multifunctional face massager
11
Apply eye cream evenly around the eye area before use. Turn on the device, select the eye
care mode and, massaging the eye area, introduce the cosmetic into the skin.
When massaging the eye skin area, be especially careful and try to gently put the head to
the skin.
When using the device, do not press the head too hard against the skin. Move the head
along the skin at a slow pace and do not stay in one place for too long.
The frequency of activities related to the use of the device depends on the individual
needs of the skin. We recommend prior consultation with a specialist in this matter.
However, do not use the device multiple times in one day.
5. Troubleshooting
If you have problems with the unit, please refer to the following tips.
The device does
not switch on
Check that the battery is charged.
Check that the cables, plugs and sockets supplying power to the
unit are not damaged.
After switching
on, the head
does not vibrate
Make sure when holding the device you touch its side slats and
the head is in direct contact with the skin.
Perhaps there has been a damage to the device. Contact the
manufacturer's service department.
If the problem persists, contact the manufacturer's service department.
6. Cleaning of the device
To extend the service life of the device:
• WARNING! The device must not be submerged in water or washed under running
water!
• Clean the device after each use.
• Disinfect with any disinfectant or with hydrogen peroxide.
• Before cleaning, make sure that the device is switched off and is not being charged.
• For cleaning use only a dry cloth. Never use any agent with a high concentration of
acids, alkalis or abrasives.
• Store the device and its accessories in a dry place away from the reach of children,
sources of heat and moisture.
• Avoid very high temperatures, for it can shorten the life of electric and electronic
components, melt the plastic parts and destroy the battery.
The packaging of the device can be recycled in accordance with local regulations.
Symbol for corrugated cardboard (packaging material).
The packaging elements should be disposed of in appropriate containers.
Marking of the container into which the stamping should be thrown - plastic/metal.
The marking of the container into which the box - paper should be discarded.
7. Correct disposal of used equipment and battery
The device is marked with a crossed-out garbage bin, in accordance with the
European Directive 2012/19/EU on used electrical and electronic Equipment
(Waste Electrical and Electronic equipment - WEEE). Products marked with this
symbol should not be disposed of or dumped with other household waste after a
period of use. The user is obliged to get rid of used electrical and electronic
equipment by delivering it to designated recycling point in which dangerous waste are
being recycled. Collecting this type of waste in designated locations, and the actual
process of their recovery contribute to the protection of natural resources. Proper
disposal of used electrical and electronic equipment is beneficial to human health and
environment. To obtain information on where and how to dispose of used electrical and
electronic equipment in an environmentally friendly manner user should contact their
local government office, the waste collection point, or point of sale, where the equipment
was purchased.