4. The use of the equipment
4.1 Battery charging
Before using the product for the first time, the device's battery should be fully
charged. Several charge and discharge cycles may be required to reach full battery
capacity.
Avoid over-discharging the battery. This may damage or shorten its life.
The device may get warm while charging. This is normal and should not affect the
durability or performance of the device. Do not leave the charging device
unattended, as this may result in fire, damage to the device or utility equipment in the
charging area. Use only the supplied cable for charging.
To charge the device, connect the USB-C plug of the included cable to the charging
connector on the device. Connect the other end of the cable to a powered USB adapter or,
for example, a socket in a computer, power bank, etc., which at the output guarantees a
power supply of 5 V ⎓ 1 A or higher. When charging starts, the LEDs of the devices will light
up to indicate the current battery level - one LED is the lowest state, six LEDs are the highest
state - the rightmost LED will be blinking. When the battery is charged, all LEDs will light up
continuously. When charging is complete, disconnect the USB cable from the device and
the power source.
It is not possible to use the device while it is charging.
4.2 Turning the device on, off and operating it
For safety reasons the massager automatically switches off after fifteen minutes of
continuous operation. Turn the device on to use it again.
Avoid massaging one area for a long time during the massage. Gently move the
device while massaging.
Press and hold the multifunction button for about 3 seconds to switch off the device. The
massager will turn on at the lowest massage intensity. Subsequent short presses of the
multifunction button will change the massage intensity level to a higher one. When the
fourth massage intensity level is reached, another press of the multifunction button will
To Next Page
Loading...