EasyManua.ls Logo

Husqvarna 12527HV - User Manual

Husqvarna 12527HV
28 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
English
532 44 34-58
Operator’s Manual
12527HV
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
Please read the owner's manual carefully and make sure you
understand the instructions before using the machine.

Table of Contents

Questions and Answers

  • W
    William KelleyJul 31, 2025
    Why does my Husqvarna Snow Blower engine idle or run roughly?
    • M
      michael87Aug 1, 2025
      If your Husqvarna Snow Blower engine idles or runs roughly, it could be due to several reasons: * The choke might be in the FULL position. If so, move it to the OFF position. * There might be a blockage in the fuel line. Clean the fuel line. * The fuel could be stale. Empty the fuel tank and carburetor, then refill with fresh, clean gasoline. * There might be water in the fuel. Empty the fuel tank and carburetor, then refill with fresh, clean gasoline.
  • J
    Jason HouseAug 5, 2025
    Why is my Husqvarna 12527HV Snow Blower losing power?
    • L
      Laura JacobsAug 5, 2025
      If you're experiencing a loss of power with your Husqvarna Snow Blower, consider these potential causes: * The spark plug wire may be loose. Reconnect the spark plug wire. * You might be throwing too much snow. Reduce the speed and width of the swath. * The fuel tank cap could be covered with ice or snow. Remove any ice and snow on and around the fuel tank cap. * The muffler might be dirty or clogged. Clean or replace the muffler.
  • J
    Jessica ClarkAug 10, 2025
    What to do if Husqvarna 12527HV Snow Blower has loss of traction drive?
    • M
      Mackenzie HowardAug 10, 2025
      If you're experiencing a loss of traction drive or slowing of drive speed on your Husqvarna Snow Blower, it could be due to: * A worn drive belt. Check and replace the drive belt. * The drive belt being off of the pulley. Check and reinstall the drive belt.
  • C
    craig27Aug 15, 2025
    What to do if my Husqvarna 12527HV Snow Blower has loss of snow discharge?
    • N
      Nancy DiazAug 15, 2025
      If your Husqvarna Snow Blower experiences a loss of snow discharge or slowing of snow discharge, here's what might be happening: * The auger belt may be off the pulley. Check and reinstall the auger belt. * The auger belt may be worn. Check and replace the auger belt. * The discharge chute may be clogged. Clean the snow chute. * The augers or impeller may be jammed. Remove any debris or foreign objects from the augers or impeller.
  • M
    mrichardsAug 20, 2025
    How to fix excessive vibration in Husqvarna Snow Blower?
    • S
      Shelby SmithAug 20, 2025
      If your Husqvarna Snow Blower experiences excessive vibration, it could be due to loose parts or damaged augers or impeller. Tighten all fasteners and replace any damaged parts. If the vibration continues, contact an authorized service center/department.
  • D
    David GarciaOct 25, 2025
    Why my Husqvarna Snow Blower does not start?
    • D
      Dr. James LunaOct 25, 2025
      If your Husqvarna Snow Blower doesn't start, there are several potential causes: * The fuel shut-off valve may be in the OFF position. If so, turn it to the OPEN position. * The safety ignition key may not be inserted. Ensure it is inserted. * The unit may be out of fuel. Refill the fuel tank with fresh, clean gasoline. * The throttle may be in the STOP position (or the ON/OFF switch is OFF). Move the throttle to the FAST position (or the ON/OFF switch to the ON position). * The choke may be in the OFF position. Move it to the FULL position. * The primer may not have been depressed. Prime as instructed in the Operation section of this manual. * The engine may be flooded. Wait a few minutes before restarting, and do not prime. * The spark plug wire may be disconnected. Conn...

Summary

Safe Operation Practices

Training and Preparation

Instructions on familiarizing yourself with controls, preparing the unit, and safety.

Operation Safety Precautions

Key safety instructions for operating the snow thrower.

Product Information and Assembly

Product Specifications and Customer Responsibilities

Details on fuel, oil, spark plug, and owner's maintenance duties.

Parts Packed Separately

Lists and illustrates components included separately in the shipping carton.

Assembly and Pre-Operation: Unpacking and Handle Setup

Steps for safely unpacking and attaching the upper handle.

Assembly and Pre-Operation: Controls

Control Rod Installation

Instructions for installing traction drive and auger control rods.

Chute and Deflector Assembly

Procedure for mounting the discharge chute, rotator head, and deflector.

Tire Pressure Adjustment

Recommendation to adjust tire pressure for optimal performance.

Operating the Snow Thrower

Controls, Symbols, and Safety Overview

Familiarization with controls, symbols, warnings, and safety measures.

Component Identification and Functions

Diagram identifying major components, controls, and their functions.

Starting, Stopping, and Fuel Valve Usage

Procedures for starting, stopping, and using the fuel shut-off valve.

Choke and Discharge Control Operation

How to use choke control and adjust snow discharge direction.

Operating the Snow Thrower - Techniques

Clearing Clogged Chutes

Procedure for safely clearing clogged discharge chutes with the tool.

Movement and Steering Control

Using traction drive, speed control, and steering triggers for movement.

Adjustments, Refueling, and Engine Starting

Adjusting skid plates, refueling, and engine starting procedures.

Snow Throwing Tips

Advice for efficient and effective snow removal.

Maintenance

Maintenance Schedule and Basic Checks

Outlines required maintenance tasks, frequency, and pre-use checks.

Component Maintenance and Cleaning

Procedures for maintaining belts, engine oil, spark plug, and cleaning the unit.

Shear Bolt and Belt Replacement Procedures

Procedures for replacing shear bolts and belts for proper functioning.

Wheel Removal and Cable Adjustments

Procedures for removing wheels and adjusting control cable tension.

Storage and Troubleshooting

Preparing for Storage

Steps for cleaning, fueling, and storing the snow thrower and engine.

Troubleshooting Common Issues

A guide to diagnosing and resolving common problems with the snow thrower.

Warranty Information

Limited Warranty Details and Exclusions

Explanation of limited warranty coverage, exclusions, and owner responsibilities.

Obtaining Warranty Service and Chart

Procedures for contacting Husqvarna and a chart detailing warranty periods.

Husqvarna 12527HV Specifications

General IconGeneral
ManufacturerHusqvarna
Product Name12527HV
CategorySnow Blower
Clearing Width27 inches
Auger Diameter12 inches
StagesTwo-stage
Heated Hand GripsYes
Impeller Diameter12 in
Drive TypeWheel
StarterElectric
Transmission TypeFriction Disc

Related product manuals