EasyManua.ls Logo

Husqvarna 13 - Safety System Inspection; Inspecting the Safety System

Husqvarna 13
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
English 27
6008-014
6008-015
6008-016
6008-017
MAINTENANCE
5. Fit the air filter as follows:
Push the pre-filter over the paper filter.
Fit the paper filter with pre-filter in the air filter
housing and tighten the wing-nut.
Replace the plastic cover oven the air filter
housing and tighten the wing-nut.
Replacing the air filter
If the engine seems to lack power or goes irregu-
larly the reason may be that the air filter is clogged.
It is therefore important to replace the air filter at
regular intervals (see Maintenance \ Maintenance
Schedule for correct service interval)
The air filter is replaced as follows:
1. Raise the engine cover.
2. Remove the air filter housings plastic cover by
releasing the wing-nut.
4. Pull off the foam plastic pre-filter from the paper
filter and wash clean in mild detergent.
Squeeze it dry in a clean cloth.
Drench it with new engine oil. Wrap the filter in
an absorbent cloth and squeeze out excess oil.
Replace the paper filter if it is clogged with dirt.
IMPORTANT INFORMATION
Do not use compressed air to clean the
paper filter.
3. Remove the wing-nut on the air filter and lift off
the paper filter with pre-filter.

Table of Contents

Related product manuals