Husqvarna 2000 - Page 5

E
Unpacking
the
machine
Open
the carrying
case. Grasp
the machine b1'
,-:
hand wheel
and under the upper
arm of the
=.-
chine
and remove
it from the carrying
case. R:-
move the
electrical cord. Lift
the accessory rcr
somewhat upward
and draw it along the leng:th c-
the free arm.
Putting the
machine
away
Pull
out
the foot control
plug.
Wind the cord
around
your
hand,
starting at the control. Press
the
foot control
together and
place
it in its
com-
partment
with
the thick end down.
The bottom of
the foot control should
be turned toward the ma-
chine,
and hold
the
cord
in
place
beside the
foot
control in the compartment. Wind
the other cord
in the same way and
put
the cord band around
the
cord.
Lower
the
presser
foot. Make sure that all accesso-
ries are correctly
placed
in the box. Slide the acces-
sory box into
place
and
put
the cord in the box.
Then lift the
machine
into the case. Place
the
ex-
tension
plate
inside the
case-lid and the
piece
of
foam
plastic
as
protection
between the
sewing ma-
chine and the extension
plate,
I
H
Effi
4
o
o
6
r***
----l'S
::::lrl
J
J
J
J
J
J
)
)
J
J
J
J
u
J
J
J
J
J
J
J
J
J
J
J
J
J
)
)
)
)
{