To Next PageTo Next PageHow to fix the flashing error LED on a Husqvarna 215iHD45?
If the error LED flashes on your Husqvarna Trimmer, it could be due to overload, meaning the cutting attachment cannot move freely. Release the cutting attachment to resolve this. Alternatively, it could be due to temperature deviation; in this case, let the product cool down.
What does it mean when the error LED flashes on my Husqvarna 215iHD45?
If the error LED flashes on your Husqvarna Trimmer, it could be due to temperature deviation. Make sure to use the battery in temperatures between -10°C (14°F) and 40°C (104°F). It could also mean there is too much voltage. Ensure that the mains voltage aligns with the voltage stated on the rating plate of the product. Also, try removing the battery from the battery charger.
Why is the green LED flashing on my Husqvarna Trimmer?
If the green LED flashes on your Husqvarna Trimmer, it indicates low battery voltage. To resolve this, charge the battery.
Why is the red error LED flashing on my Husqvarna 215iHD45?
If the red error LED flashes on your Husqvarna Trimmer, it indicates a temperature deviation. Use the battery charger in temperatures between 5 °C (41 °F) and 40 °C (104 °F).
General| Type | Hedge Trimmer |
|---|---|
| Battery Voltage | 36 V |
| Cutting Length | 45 cm |
| Vibration Level | 2.5 m/s² |
| Blade Type | Dual Action |
Husqvarna 215iHD45 is a battery hedge trimmer with an electrical motor.
Use the product to cut branches and twigs. Do not use the product for other tasks.
WARNING: This product can be dangerous and cause serious injury or death...
Warnings, cautions and notes are used to point out specially important parts of the manual.
Read all safety warnings and all instructions. Failure to follow...
Keep work area clean and well lit. Avoid body contact with earthed surfaces.
Stay alert, watch what you are doing and use common sense when operating a power tool.
Do not force the power tool. Use the correct power tool for your application.
Recharge only with the charger specified by the manufacturer.
Have your power tool serviced by a qualified repair person using only identical replacement parts.
Use both hands when operating the hedge trimmer. Using one hand could cause loss of control...
Remove the battery to prevent the product from being started by accident.
If you encounter a situation where you are uncertain how to proceed you should ask an expert.
Use approved personal protective equipment when you use the product.
Read the warning instructions that follow before you use the product.
Press and hold the start/stop button (A). (Fig. 23)
The longer parts of the blades (A) operate as blade guards.
Only use the BLi battery. Refer to Technical data on page 15.
Risk of electrical shock or short circuit if the safety instructions are not obeyed.
Remove the battery before you do maintenance, other checks or assemble the product.
Connect the battery charger to the voltage and frequency that is specified on the rating plate.
Fully charge the battery. Push the battery into the battery holder of the product.
Charge the battery if it is the first time that you use it. A new battery is only 30% charged.
Examine the work area. Remove objects that can be thrown out.
Start near the ground and move the product up along the hedge when you cut the sides.
This product has a power saving function, SavE.
Release the power trigger and the front handle trigger. Push the start/stop button until the green LED goes off.
The following is a list of the maintenance steps that you must do on the product.
Examine the battery for damages, for example cracks.
Clean the product with a dry cloth after use.
Clean the cutter blades from unwanted materials with an anti corrosion cleaning agent before and after you use the product.
Clean the blades from unwanted materials before and after you use the product.
Apply grease to the gear housing if the gear has been disassembled by an approved servicing dealer.
LED screen: The error LED flashes.
LED display: The green LED flashes.
Problem: Red error LED flashes.
The supplied Li-ion batteries obey the Dangerous Goods Legislation requirements.
Recycle it at a recycling station for electrical and electronic equipment.
Motor type: BLDC
Weight without battery, kg: 3.2
Type: Double sided
Sound power level, measured dB(A): 87
Sound pressure level at the operator's ear, measured according to EN 62841-4-2, dB(A): 79
Vibration levels (an), front/rear, m/s²: 2.1/1.7
Battery: BLi10. Type: Lithium-ion.
Battery charger: QC80, 40-C80.
Husqvarna AB, SE-561 82 Huskvarna, Sweden, declare that the hedge trimmers Husqvarna 215iHD45...
Husqvarna AB, SE-561 82 Huskvarna, Sweden, declare on our sole responsibility that the represented product...
