Need help?Do you have a question about the Husqvarna 343R, 345RX, 343F, 345FX, 345FXT and is the answer not in the manual?
Covers fire risks, poisonous fumes, and general safe practices for equipment operation.
Details on special tools and tips for sealing faces and rings.
Step-by-step instructions for disassembling the starter unit.
Step-by-step instructions for assembling the starter unit.
Procedures for checking the ignition spark and troubleshooting.
Step-by-step guide for replacing the spark plug cover.
Instructions for dismantling components of the electrical system.
Details on the removal and replacement of drive dogs.
Information on the maintenance and repair of heated handles.
Instructions for cleaning and maintaining the air filter.
How to check and maintain the tank venting system.
Procedure for removing and replacing the fuel filter.
Information on the fuel pump's function and replacement.
Comprehensive guide to carburettor dismantling, assembly, and settings.
Detailed instructions on adjusting carburettor settings for optimal performance.
Step-by-step guide for disassembling the centrifugal clutch.
Instructions for correctly assembling the centrifugal clutch.
Procedures for removing and inspecting the clutch drum.
Steps to dismantle the angle gear assembly.
Instructions for assembling the angle gear.
Details on replacing the drive axle guide and O-ring.
Procedure for removing the cylinder and piston.
Instructions for removing, checking, and fitting the decompression valve.
Guidance on removing and inspecting the inlet manifold.
How to clean and inspect piston, cylinder, and rings.
Steps for assembling the piston and cylinder components.
Troubleshooting common piston and cylinder failures.
Steps for dismantling the crankcase and crankshaft.
Procedures for inspecting crankshaft, bearings, and sealing rings.
Instructions for assembling the crankshaft and crankcase.
How to perform leakage tests on the crankcase.
Specific tools required for starter system maintenance.
Specific tools required for electrical system maintenance.
Specific tools required for fuel system maintenance.
Specific tools required for centrifugal clutch maintenance.
Specific tools required for angle gear maintenance.
Specific tools required for cylinder and piston maintenance.
Specific tools required for crankshaft and crankcase maintenance.
General equipment used in the workshop for repairs.
To Next Page
General
