52 Instruction book Lily 555/545
Maintenance
Replacing the stitch plate
Replace the stitch plate about 5 mm
in front of the rear edge and push
it backward. Replace the bobbin
cover.
Cleaning
When necessary, the feed teeth and
the bottom of the bobbin area must
be cleaned with the brush, which
you will fi nd with the accessories.
Removing the stitch plate
Remove the presser foot and the
bobbin cover. Lower the feed teeth.
Place the stitch plate opener on the
brush. There is a recess at the rear
of the stitch plate. Insert the stitch
plate opener at the recess and turn.
Care of the machine
To keep your sewing machine ope-
rating satisfactorily, it requires, like
other precision machines, regular
cleaning. No lubrication (oiling) is
needed.
Changing the light bulb
The light bulb is placed to the left of
the needle. Place the rubber sheath
found in the accessory box with its
deep hole around the bulb. Do not
turn the bulb, just pull it down to
remove the bulb.
When inserting, place the rubber
sheath with its shallow hole around
the new bulb, insert the bulb by
pushing it up.
Use light bulb designed as indicated
on the front of the machine.
Maintenance
To Next Page
Loading...
