Husqvarna 7021P User Manual (English)

Other manuals for Husqvarna 7021P

Questions and Answers:

J
Jacqueline RichardsonAug 19, 2025
Why is my Husqvarna 7021P losing power?
- G
  George PriceAug 19, 2025
  A loss of power in your Husqvarna lawn mower can occur for several reasons: * The rear of the mower housing or blade dragging in heavy grass: Raise the cutting height. * Cutting too much grass: Raise the cutting height. * A dirty air filter: Clean or replace the air filter. * Buildup of grass, leaves, and trash under the mower: Clean the underside of the mower housing. * Too much oil in the engine: Check the oil level. * Walking speed too fast: Cut at a slower walking speed.
J
Jeffery KnightAug 22, 2025
How to troubleshoot an uneven cut with my Husqvarna 7021P?
- M
  Mark KellyAug 22, 2025
  An uneven cut from your Husqvarna lawn mower can be due to: * A worn, bent, or loose blade: Replace the blade and tighten the blade bolt. * Uneven wheel heights: Set all wheels at the same height. * Buildup of grass, leaves, and trash under the mower: Clean the underside of the mower housing.
J
Jordan KingAug 25, 2025
Why my Husqvarna 7021P does not start?
- R
  rebeccajohnsonAug 26, 2025
  If your Husqvarna Lawn Mower doesn't start, several factors could be the cause. First, check if the air filter is dirty and clean or replace it. Ensure the fuel tank isn't empty; if it is, refill it. Stale or water-contaminated fuel can also prevent starting, so empty the tank and refill with fresh, clean gasoline. Make sure the spark plug wire is connected, and the spark plug isn't bad (replace if necessary). Also, verify that the control bar is depressed to the handle, and the fuel valve lever is in the ON position. For models with a battery, check if the battery is weak and needs charging or if the battery connector is disconnected and needs connecting. Finally, inspect the blade for looseness or the blade adapter for breakage; tighten or replace as needed.
E
Elizabeth ZimmermanAug 27, 2025
Why is my Husqvarna 7021P Lawn Mower so hard to push?
- U
  ubrownAug 28, 2025
  If your Husqvarna lawn mower is difficult to push, here are some possible reasons: * Grass is too high or wheel height is too low: Raise the cutting height. * The rear of the mower housing or blade dragging in heavy grass: Raise the rear of the lawn mower housing one setting higher. * Grass catcher is too full: Empty the grass catcher. * Handle height is not right for you: Adjust handle height to suit.
E
eric60Aug 30, 2025
How to fix poor uneven cut from Husqvarna 7021P?
- J
  Jennifer MorrisAug 30, 2025
  If your Husqvarna Lawn Mower is leaving an uneven cut, the blade might be worn, bent, or loose; replace the blade or tighten the blade bolt. Ensure that all wheel heights are set evenly. Also, check for and remove any buildup of grass, leaves, or trash under the mower housing.
M
morgan26Sep 2, 2025
What to do if the grass catcher is not filling on my Husqvarna Lawn Mower?
- G
  Gabriela TaylorSep 2, 2025
  If the grass catcher on your Husqvarna lawn mower isn't filling properly, consider these points: * Cutting height is too low: Raise the cutting height. * Lift on blade worn off: Replace the blade. * Catcher not venting air: Clean the grass catcher.
S
Steven AllenSep 4, 2025
Why is the starter rope hard to pull on my Husqvarna Lawn Mower?
- O
  ocarterSep 5, 2025
  If the starter rope on your Husqvarna Lawn Mower is hard to pull, make sure the engine flywheel brake is not engaged by depressing the control bar to the upper handle before pulling. If the blade is dragging in grass, move the mower to a cleared or hard surface before starting. If these steps don't resolve the issue, the blade adapter might be broken and need replacement.
C
charlesstoneSep 7, 2025
What to do if Husqvarna Lawn Mower is hard to push?
- P
  phughesSep 7, 2025
  If your Husqvarna Lawn Mower is hard to push, the grass may be too high, or the wheel height is too low; try raising the cutting height. Check if the rear of the mower housing is dragging in heavy grass and raise it one setting higher. Make sure the grass catcher isn't too full and empty it if needed. Adjust the handle height to a comfortable position for you.
A
Andrew LongSep 10, 2025
Why is my Husqvarna Lawn Mower vibrating excessively?
- K
  Kayla EricksonSep 10, 2025
  Excessive vibration in your Husqvarna Lawn Mower can be due to a worn, bent, or loose blade; replace the blade and tighten the blade bolt.
J
Jennifer MyersSep 13, 2025
What to do if grass catcher is not filling on Husqvarna 7021P?
- R
  rogersrobertSep 13, 2025
  If the grass catcher on your Husqvarna Lawn Mower isn't filling, the cutting height might be too low; raise it. A worn blade can also cause this issue, so replace the blade. Additionally, ensure the catcher is venting air properly by cleaning the grass catcher.

Husqvarna 7021P Specifications

General

Cutting Width	21 inches
Drive System	Push
Grass Collector	Yes
Mulching Capability	Yes
Engine Displacement	160 cc
Bagging Capability	Yes
Side Discharge	Yes
Starter Type	Recoil
Engine Type	4-stroke
Wheel Size	8-inch front, 12-inch rear
Engine	Briggs & Stratton