MAINTENANCE
T
R
A
C
T
0
R
G
I
N
E
MAINTENANCE
SCHEDULE
Sheck Brake Operation
Sheck Tire Pressure
Check Operator Presence & ROS Systems
Sheck for Loose Fasteners
ShecWReplace Mower Blades
Lubrication Chart
Sheck Battery Level
Slean Battery and Terminals
Sheck Transaxle Cooling
Sheck Mower Levelness
Sheck V-Belts
Check Engine Oil Level
Dhan,qe Enqine Oil (with oil filter)
Shan ge Engine Oil (without oil filter
Clean Air Filter
Clean Air Screen
Inspect Muffler/Spark Arrester
Replace Oil Filter (If equipped)
Clean Engine Cooling Fins
Replace Spark Plug
qeplace Air Filter Paper Cartridge
R_=place Fuel Filter
m
BEFORE
EACH
USE
,I
v'
v"
v'
m
EVERY
8
HOURS
r,
v'
m
EVERY
25
HOURS
V_1,2
V',
EVERY
5O
HOURS
v'
V#1,2
v'
EVERY
100
HOURS
v'
v'
V_,2
V'.
V'
EVERY
SEASON
v"
v'
BEFORE
STORAGE
v"
v'
v'
v"
v'
- Change more often when operating under a heavy load or
in high ambient temperatures.
2 - Service more often when operating in dirty or dusty conditions.
3 - Replace blades more often when mowing in sandy soil.
4 - Not required if equipped with maintenance-free battery.
GENERAL RECOMMENDATIONS
The warranty on this tractor does not cover items that have
been subjected to operator abuse or negligence. To receive
full value from the warranty, operator must maintain tractor
as instructed in this manual.
Some adjustments will need to be made periodically to
properly maintain your tractor.
At least once a season, check to see if you should make
any of the adjustments described in the Service and
Adjustments section of this manual.
• At least once a year you should replace the spark plug,
clean or replace air filter, and check blades and belts
for wear. A new spark plug and clean air filter assure
proper air-fuel mixture and help your engine run better
and last longer.
BEFORE EACH USE
• Check engine oil level.
• Check brake operation.
• Check tire pressure.
• Check operator presence and
ROS systems for proper operation.
• Check for loose fasteners.
LUBRICATION CHART
(_) _ SPINDLE ZERK
(_) FRONT FRONT
WHEEL WHEEL
BEARING BEARING
ZERK ZERK
'(_ ENGINE
STEERING
SECTOR GEAR
TETH
_ MANDREL
ZERKS
_) General Purpose Grease
@ Refer to Maintenance "ENGINE" Section
IMPORTANT: DO NOT OIL OR GREASE THE PIVOT POINTS
WHICH HAVE SPECIAL NYLON BEARINGS. VISCOUS
LUBRICANTS WILL ATTRACT DUST AND DIRT THAT WILL
SHORTEN THE LIFE OFTHE SELF-LUBRICATING BEARINGS.
IFYOU FEELTHEY MUST BE LUBRICATED, USE ONLY A DRY,
POWDERED GRAPHITE TYPE LUBRICANT SPARINGLY.
14
To Next Page
Loading...
