English – 27
• Remove the blade bolt by turning the bolt
counter-clockwise. Remove blade and attaching
hardware: bolt, lock washer and hardened washer.
• Remove the screw and the pulley.
• Pull out the belt and thread it over the adapter.
Replace the drive belt.
IMPORTANT! Always use genuine parts.
• Thread the new belt over the adapter and place the
belt on engine pulley.
• Route the belt over the stripper ring into the hole of
the chassis.
• Reinstall the transmission pulley and place the belt
on the pulley.
• Reinstall drive cover.
• Reinstall the blade. See instructions in the section
”Replacing the blades”.
• Tighten spark plug.
MAINTENANCE
To Next Page
Loading...
