2
12
502 51 67-01
502 51 67-01 502 71 27-01
502 50 23-01
502 51 67-01
Wheels and drive system
Dismantle the wheel link on the right-hand
side.
Remove the barrel nut (C) holding the
wheel link (D) to the front axle on the right-
hand side.
Remove the wheel link along with
attached height setting lever.
Remove the spring and the rear axle.
Assembly
Assemble in the reverse order as set out
for dismantling.
Assembly
Assemble the different components in the
reverse order as set out for dismantling.
The markings made earlier on the front
axle and the wheel link make it easier to
position these components.
Do not forget the spacer washer inside the
wheel.
Rear axle with drive
Dismantling
Remove all covers preventing access to
the rear axle.
Rear axle with drive
Dismantling
Remove all covers preventing access to
the rear axle.
The rear cover has a snap-on fastening.
This can be undone by pressing the lower
edge of the snap-on fastening.
Remove the 4 screws holding the upper
cover and fold it to one side.
Dismantle both rear wheels and the
connecting rod for the height control from
the front wheel.
Remove the 4 screws holding the upper
cover.
Fold up the cover and disconnect the drive
speed cable. The cable is held in place by
a spring on the lower side of the cover (Be
models only).
With electric starter (see chapter “Electric
starter”).
Dismantle both rear wheels in the same
way as described above.
Set the height control to the highest cutt-
ing height and dismantle the connecting
rod from the front wheel.
Press the lock button on the height control
down to release the spring tension.
To Next Page
Loading...
