4. Attach the new belt in reverse sequence.
Note: A decal on the inner side of the cover shows
how to put the belt.
9.6.7 To replace the belt on C103
1. Remove the cutting deck cover.
2. Remove the cutting deck.
3. Lift the lock on the tie rod bolt.
4. Remove the tie rod bolt.
5. Remove the bolt for the deck frame.
6. Remove the 2 screws on the lock and pull out the
deck frame.
7. Remove the 2 deck frame bolts.
8. Loosen the screws on the cutting cover. Lift up the
deck frame and pull out the cutting cover.
9. Loosen the tension spring and pull off the belt.
10. Assemble in opposite sequence.
855 - 002 - 28.03.2019 Repair instructions - 55
To Next Page
Loading...
