Need help?Do you have a question about the Husqvarna R135 and is the answer not in the manual?
General| Brand | Husqvarna |
|---|---|
| Model | R135 |
| Category | Brush Cutter |
| Language | English |
Precautions for handling fuel safely to prevent fires.
Warnings about exhaust fumes and ventilation requirements.
Importance and use of specialized tools for efficient repairs.
Procedures for cleaning contact surfaces and fitting gaskets.
Guidelines for fitting and replacing sealing rings correctly.
Step-by-step procedure for disassembling the starter assembly.
Step-by-step procedure for reassembling the starter assembly.
Procedure for replacing worn drive dogs in the starter.
Method for verifying the spark from the ignition system.
Steps to diagnose and resolve ignition issues.
Procedures for disassembling electrical system parts.
Procedures for reassembling electrical system parts.
Cleaning and replacing the air filter for optimal engine performance.
Checks and cleaning of the fuel tank vent for proper operation.
Procedure for accessing and replacing the fuel filter.
Explains fuel pump operation and replacement if faulty.
Dismantling, cleaning, and adjusting the carburetor for performance.
Disassembly, assembly, and adjustment of the throttle control.
Fine-tuning engine idle speed for starting.
Adjusting H/L needles and idle speed for optimal performance.
Steps to disassemble the centrifugal clutch assembly.
Steps to reassemble the centrifugal clutch assembly.
Procedures for dismantling and assembling the clutch drum and drive axle.
Specifies the gear ratios for different models.
Steps to dismantle the angle gear assembly.
Steps to assemble the angle gear assembly.
Procedures for dismantling and assembling the drive axle.
Steps to remove the cylinder and piston components.
Procedures for cleaning and inspecting cylinder/piston parts.
Troubleshooting common piston and cylinder wear issues.
Practical advice and specifications for acceptable wear.
Steps to reassemble the cylinder and piston.
Steps to disassemble the crankshaft and crankcase.
How to check the crankshaft for wear and damage.
Steps to reassemble the crankshaft and crankcase.
Tools required for starter maintenance and repair.
Tools for electrical system service.
Tools for fuel system maintenance and repair.
Tools for servicing the centrifugal clutch.
Tools needed for angle gear maintenance.
Tools for cylinder and piston service.
Tools for crankshaft and crankcase service.
General workshop equipment and accessories.
Detailed engine parameters like displacement, bore, stroke, and output.
Ignition system parameters like max speed and pre-ignition.
Carburettor type, needle settings, and idle speed.
Data related to the centrifugal clutch, like diameter and engage speed.
Specifications for the angle gear and drive axle.
Unit weight and tank volume.
To Next Page
