Husqvarna ST 227P User Manual (English)

Other manuals for Husqvarna ST 227P

Questions and Answers:

M
Michael PattonSep 2, 2025
Why is my Husqvarna ST 227P Snow Blower losing power?
- A
  angelahicksSep 2, 2025
  Your Husqvarna Snow Blower might be losing power due to: * The spark plug cable not being connected: Connect the cable to the spark plug. * The product throwing too much snow: Decrease the speed and the width of the swath. * The fuel tank cap being covered with ice or snow: Remove the ice and the snow on and around the fuel tank cap. * A dirty or clogged muffler: Clean or replace the muffler. * Improper cable length: Adjust the cable. * A blocked muffler: Make sure that the engine is cool. Clear the blockage. * The air intake of the carburetor being blocked: Make sure that the engine is cool. Clear the blockage.
E
Edward PerrySep 1, 2025
Why does my Husqvarna ST 227P engine idles or runs roughly?
- W
  William HarringtonSep 1, 2025
  If your Husqvarna Snow Blower engine idles or runs roughly, it could be due to several reasons. Make sure the choke is in the OFF (CLOSE) position. Clean the fuel line if it's blocked. If there is water in the fuel or the fuel is too old, empty the fuel tank and carburetor, then fill the fuel tank with fresh, clean gasoline.
M
Michael IbarraAug 31, 2025
What to do if auger rotation fails after releasing the grip on my Husqvarna Snow Blower?
- L
  Lisa FreemanAug 31, 2025
  If the auger rotation fails after releasing the grip on your Husqvarna Snow Blower, check that the drive belt and the discharge deflector are aligned, and adjust them if necessary.
E
eflemingAug 29, 2025
What to do if Husqvarna ST 227P has loss of traction drive or snow discharge?
- B
  brooksjacobAug 29, 2025
  If your Husqvarna Snow Blower experiences loss of traction drive or snow discharge, consider these: * Adjust the cable and belt if the belt slips. * Check and replace the belt if worn, and adjust the pulley. * Check and reinstall the belt if it's off the pulley, then adjust the pulley. * Clean the chute deflector if it's clogged. * Remove any debris or foreign objects from the augers. * Replace the broken shear pin, if broken. * Remove any excessive snow and ice buildup between track components. * Let the friction disc dry if it is wet.
B
Bethany LinAug 28, 2025
Why is the starter rope handle hard to pull on my Husqvarna ST 227P Snow Blower?
- O
  ojohnsonAug 29, 2025
  If the starter rope handle on your Husqvarna Snow Blower is hard to pull: * If the starter rope handle is frozen, slowly pull out as much rope out of the starter as possible and release the starter rope handle. If the engine does not start, repeat the procedure or use the electrical starter. * Make sure the starter rope is not interfering with any cables or hoses.
N
Nicholas WeissAug 27, 2025
What to do if my Husqvarna Snow Blower has excessive vibration or handle movement?
- F
  Frank RowlandAug 27, 2025
  If your Husqvarna Snow Blower has excessive vibration or handle movement, check these: * Tighten all fasteners and replace any damaged parts. * Ensure the handles are locked into position. * Tighten the adjustment lever nuts until the handle feels safe.
M
michaelwilliamAug 27, 2025
Why does my Husqvarna ST 227P Snow Blower engine idle or run roughly?
- J
  Jessica MillsAug 27, 2025
  If your Husqvarna Snow Blower engine idles or runs roughly, it could be due to several reasons: * Ensure the choke is in the OFF (CLOSE) position. * Check the fuel line and clean it if it's blocked. * If there's water in the fuel or the fuel is too old, empty the fuel tank and carburetor and fill it with fresh, clean gasoline. * The belt may be stretched, in which case you should replace the auger v-belt.
X
xnashAug 25, 2025
What to do if my Husqvarna ST 227P has decreased power?
- F
  franklinmackenzieAug 26, 2025
  If your Husqvarna Snow Blower is experiencing decreased power, consider the following: * Ensure the spark plug cable is securely connected. * If you're throwing too much snow, decrease the speed and width of the swath. * Remove any ice or snow from around the fuel tank cap. * Inspect the muffler; clean or replace it if it's dirty or clogged. * Adjust the cable if the length is improper. * Clear any blockage from the muffler and the air intake of the carburetor, ensuring the engine is cool before doing so.

Husqvarna ST 227P Specifications

General

Clearing Width	27 inches
Throwing Distance	Up to 50 feet
Drive System	Friction disc
Number of Forward Gears	6
Number of Reverse Gears	1
Power Steering	No
Remote Chute Rotation	Yes
Heated Handles	No
Headlight	Yes
Auger Type	Serrated
Electric Start	Yes
Skid Shoes	Yes
Auger Material	Steel
Stages	2
Clearing Depth	20 inches