To Next PageTo Next PageWhat to do if Husqvarna Cutter water pump stops pumping water?
If the water pump on your Husqvarna Cutter stops pumping water, ensure the hose to the water pump is connected and that the valve on the water pump is set to the correct position. You can also try removing the water pump from the water and putting it back.
What to do if my Husqvarna Lathe does not start?
If your Husqvarna Lathe does not start, ensure that the power supply is correctly plugged in and check the power cord.
What to do if the water pump of my Husqvarna Lathe does not start?
If the water pump of your Husqvarna Lathe does not start, make sure that the hose is connected and not damaged and that there is voltage in the water pump circuit and mains supply.
Why does the water pump stop pumping water in my Husqvarna Lathe?
If the water pump stops pumping water in your Husqvarna Lathe, you should: * Make sure the hose to the water pump is connected. * Make sure the valve on the water pump is set to the correct position. * Make sure that the water pump is clean. * Take out the water pump from the water and put it back.
General| Blade Diameter | 300 mm |
|---|---|
| Weight | 8.5 kg |
| Voltage | 230 V |
| Max Cutting Depth | 100 mm |
| Cutting depth max | 100 mm |
