Need help?Do you have a question about the Husqvarna WR 300 and is the answer not in the manual?
General| Displacement | 293.2 cc |
|---|---|
| Transmission | 6-speed |
| Final Drive | Chain |
| Seat Height | 970 mm |
| Engine Type | 2-stroke, single cylinder |
| Bore x Stroke | 72 mm x 72 mm |
| Cooling System | Liquid cooled |
| Front Brake | Disc brake |
| Rear Brake | Disc brake |
Engine specifications including bore, stroke, compression ratio, and fuel feeding.
Frame construction details like material, steering angle, and front fork caster.
Details on front and rear suspension, including fork type, manufacturer, and travel.
Specifications for front and rear brakes, including disc diameter and caliper type.
Information on front and rear wheel rims, including manufacturer and dimensions.
List of checks and operations to perform before delivery.
Schedule of routine maintenance tasks based on time or mileage.
Common engine problems, their causes, and recommended solutions.
Troubleshooting for electrical system issues like spark plug or generator problems.
Procedure for checking and adjusting ignition timing.
Instructions for lubricating the gearbox and primary transmission.
Procedures for adjusting front fork compression and extension.
Adjusting suspension based on track conditions.
Steps to remove the seat from the motorcycle.
Procedure for removing the engine from the frame.
Steps for removing the engine cooling system components.
Steps to disassemble the cylinder.
Procedure for disassembling the clutch assembly.
Instructions for cleaning engine components.
Measurement and inspection of the cylinder.
Cleaning and measurement of the piston.
Frame dimensions and inspection points.
Details on the front suspension unit, including specifications and components.
Procedures for removing and reassembling the rear wheel.
Specifications for front and rear tires, including size and pressure.
Overview of the braking system and its main components.
Step-by-step guide for bleeding the front brake system.
Procedure for checking and replacing brake pads.
Explanation of the wiring diagram symbols and colors.
Components and function of the electronic ignition system.
Description of the digital instrument display and warning lights.
Procedure for checking and maintaining the coolant level.
Steps for overhauling the engine cooling system.
Instructions for disassembling the exhaust valves.
List of optional parts available for the motorcycle.
Instructions for installing the Mikuni TMX 38 carburetor kit.
List of special tools required for maintenance and repair.
Table of tightening torques for various components.
Specific notes for USA-CDN models.
Information regarding the noise emission warranty.
Warning against tampering with the noise control system.
Maintenance and cleanout instructions for the spark arrester.
To Next Page