Need help?Do you have a question about the Husqvarna 250 WR and is the answer not in the manual?
General| Displacement | 249 cc |
|---|---|
| Fuel System | Carburetor |
| Transmission | 6-speed |
| Final Drive | Chain |
| Rear Suspension | Monoshock |
| Front Brake | Disc |
| Rear Brake | Disc |
| Engine Type | 2-stroke |
| Bore x Stroke | 66.4 mm x 72 mm |
| Starter | Kick |
Procedure for removing the cylinder head, cylinder, and piston, including associated hoses and components.
Inspection of cylinder bore, piston skirt, piston rings, and reed valve for wear and damage.
Instructions for assembling the piston, rings, and cylinder onto the crankcase, ensuring correct orientation and sealing.
Steps to remove the outer and inner flywheel, stator plate, and related components of the ignition system.
Procedures for installing the stator plate, flywheel, and rotor, including critical timing adjustments and checks.
Detailed steps for the disassembly and reassembly of the water pump and its components.
Procedure for removing, checking, and reinstalling the gear shift lever and its shaft.
Steps for dismantling and assembling the kick starter mechanism, including pawl and spring.
Instructions for disassembling the clutch assembly, clutch hub, and gear shift mechanism components.
Methods for checking wear on clutch discs, friction plates, and the gear shift mechanism parts.
Reassembly of the clutch and gear shift mechanism, including play adjustment for the clutch lever.
Checking for play in the connecting rod big end bearing to assess its condition.
Detailed steps for disassembling, cleaning, and reassembling the crankshaft components.
To Next Page