Husqvarna YTH24V48 - User Manual

Questions and Answers

A
Angela RhodesAug 25, 2025
Why will my Husqvarna YTH24V48 Lawn Mower engine not turn over?
- J
  Julie AustinAug 25, 2025
  If the engine on your Husqvarna Lawn Mower will not turn over, make sure the brake pedal is depressed. Also, ensure the attachment clutch is disengaged. If the battery is weak or dead, recharge or replace it. Check for a blown fuse and replace it if necessary. Clean any corrosion from the battery terminals. Inspect all wiring for loose connections or damage. If these steps don't resolve the issue, the ignition switch, solenoid, or starter might be faulty and need to be checked or replaced. If the problem persists, there may be faulty operator presence switch(es), in which case you should contact an authorized service center/department.
J
John YoungAug 25, 2025
Why will my Husqvarna YTH24V48 Lawn Mower battery not charge?
- E
  emilyleeAug 26, 2025
  If your Husqvarna Lawn Mower battery will not charge, it could be due to bad battery cell(s), so consider replacing the battery. Poor cable connections can also prevent charging, so check and clean all connections. If your mower is equipped with a regulator, a faulty one could be the issue, requiring replacement. Lastly, a faulty alternator could also be the cause, so replace it if necessary.
K
kbrownAug 27, 2025
How to troubleshoot why my Husqvarna YTH24V48 Lawn Mower will not start?
- K
  Kim DelgadoAug 27, 2025
  If your Husqvarna Lawn Mower won't start, several factors could be at play. First, ensure the fuel tank is adequately filled. If the engine isn't choked correctly, consult the “TO START ENGINE” section in the Operation manual. If the engine is flooded, wait a few minutes before trying again. Other potential issues include a bad spark plug (replace it), a dirty air filter (clean or replace it), a dirty fuel filter (replace it), water in the fuel (empty the fuel tank and carburetor, refill with fresh gasoline, and replace the fuel filter), loose or damaged wiring (check all wiring), or engine valves that need adjustment (contact an authorized service center/department).
B
Brenda CastroAug 27, 2025
Why does my Husqvarna Lawn Mower engine click but not start?
- H
  heathercampbellAug 27, 2025
  If the engine of your Husqvarna Lawn Mower clicks but doesn't start, the issue might stem from a weak or dead battery (recharge or replace it), corroded battery terminals (clean them), loose or damaged wiring (check all wiring), or a faulty solenoid or starter (check/replace the solenoid or starter).
V
Victor MosesSep 18, 2025
Why does my Husqvarna Lawn Mower have excessive vibration?
- J
  John BrooksSep 18, 2025
  If your Husqvarna Lawn Mower has excessive vibration, check for a worn, bent, or loose blade (replace the blade and tighten the blade bolt). A bent blade mandrel (replace the blade mandrel) or loose/damaged parts (tighten loose parts and replace damaged parts) could also be the cause.
J
Jonathan KennedySep 15, 2025
Why does my Husqvarna YTH24V48 have loss of drive?
- C
  cromeroSep 15, 2025
  If your Husqvarna Lawn Mower has loss of drive, ensure the freewheel control is in the “engaged” position. If equipped, check for debris on the steering plate. A worn, damaged, or broken motion drive belt should be replaced. If air is trapped in the transmission, purge it. Finally, check for a missing axle key and install it at the rear wheel.
H
Heather MillerSep 16, 2025
Why does my Husqvarna YTH24V48 Lawn Mower engine dies when tractor is shifted into reverse?
- A
  awoodSep 16, 2025
  If your Husqvarna Lawn Mower engine dies when shifted into reverse, it may be because the Reverse Operation System (ROS) is not "ON" while the mower or other attachment is engaged. To resolve this, turn the ignition key to the ROS "ON" position.
T
Todd PerrySep 5, 2025
How to prevent Husqvarna YTH24V48 Lawn Mower engine from backfiring when turning engine off?
- K
  Kristin LopezSep 5, 2025
  To prevent your Husqvarna Lawn Mower engine from backfiring when turning it off, move the throttle control between half and full speed (fast) position before stopping the engine.
R
Raymond Wilson MDSep 3, 2025
What to do if Husqvarna Lawn Mower engine clicks but will not start?
- F
  floresandrewSep 3, 2025
  If your Husqvarna Lawn Mower engine clicks but won't start, it could be due to a weak or dead battery, so try recharging or replacing it. Another potential cause is corroded battery terminals, so clean them thoroughly. Inspect the wiring for any loose or damaged connections and address them accordingly. Finally, a faulty solenoid or starter could be the problem, requiring you to check or replace them.
M
Mark YoungSep 4, 2025
Why does my Husqvarna YTH24V48 Lawn Mower have a poor cut that is uneven?
- J
  Julie FloresSep 4, 2025
  If your Husqvarna Lawn Mower provides a poor cut that is uneven, it could be due to a worn, bent, or loose blade. Replace the blade and tighten the blade bolt. The mower deck might not be level, so level it. Check for buildup of grass, leaves, or trash under the mower and clean it. A bent blade mandrel could also be the cause, so replace it. Finally, check for clogged mower deck vent holes from buildup of grass, leaves, and trash around mandrels, and clean around the mandrels to open vent holes.

Husqvarna YTH24V48 Specifications

General

Engine Power	24 hp
Engine Type	V-Twin
Cutting Width	48 inches
Transmission Type	Hydrostatic
Fuel Capacity	3 gallons
Deck Material	Steel
Engine Manufacturer	Briggs & Stratton
Warranty	3 years
Cutting Height Range	1.5 - 4 inches
Turning Radius	16 inches