HUST CNC H6D-T - Page 131

3 G/M Codes
3 - 69
M-CODE Function
.
M50
Set Spindle 1 to Servo Axis Mode.
M51
Set Spindle 1 back to Spindle Mode.
M55
Start in-process Tool offset change instant avail.
M60
Set Spindle 2 to Servo Axis Mode.
M61
Set Spindle 2 back to Spindle Mode.
M63
Spindle 2 CW
M64
Spindle 2 CCW
M65
Spindle 2 Stop
M70
Set Spindle 3 to Servo Axis Mode.
M71
Set Spindle 3 back to Spindle Mode.
M73
Spindle 3 CW
M74
Spindle 3 CCW
M75
Spindle 3 Stop
M80 Enable axial direction without homing
M81 Disable axial direction without homing
M84 Spindle brake hold
M85 Spindle brake release
M98 Call subprogram
M99 Program cycle
M30 Program end
M300 Enable round-angle connection between blocks
M301 Disable round-angle connection between blocks
M362
Switch to Spindle 1
M364
Switch to Spindle 2
M365
Switch to Spindle 3
Using CW, CCW of spindle:
1. M03: First spindle clockwise (CW)
Format:
(1) M03 SXXXX
EX.: M03 S1000 Command first spindle to rotate CW at 1000rpm.
(2) M03
If M03 is not followed by an S-code, spindle rpm is not specified; spindle