HUST CNC H6D-T - Page 140

HUST CNC H6D-T Manual
3 - 78
Starting of tool-tip radius compensation:
With the G41.G42 command alone, the tool will not perform a movement according to
tool-tip radius compensation. A tool-tip radius compensation does not start on G00; it
only starts on a G01, G02, or G03 command.
When a G41.G42 command exists in the same block with a move command, the move
command is processed as a G01 command.
1. In the case of a single command of Chamfer inside G41.G42: (Fig. 3-59)
Program path
T
ool-tip radius center path
Intersecting
point
Program path
Program path
Program path
T
ool-tip radius center path
T
ool-tip radius center path
T
ool-tip radius center path