HUST CNC H6D-T - Page 156

HUST CNC H6D-T Manual
3 - 94
Function Parameter Action
Interference check
alarm
Parameter 20=0 Issues alarm and stop machine before
entering block of interference.
Interference avoidance
function
Parameter 20=1 Alter the path automatically to avoid
interference.
Interference check
disable
Parameter 20=2 Cutting action continues, allowing cutting
into workpiece.
Details (Ex.)
Fig 3-77
1. Interference check alarm: An alarm occurs before executing N1, process stops.
2. Interference avoidance function: N1 and N3 calculate intersection point, for
altering the path to avoid interference.
3. Interference check disabled: continue cutting into N1 and N3 lines.
Interference handling alarm
An interference alarm occurs when any of the following conditions take place:
Avoidance path
Tool diameter
Cutting with N2
Cutting with N2