HUST CNC H6D-T Manual
3 - 98
G52 X15.0 Z30.0 ;
G00 X10.0 Z10.0 ;
(Local Coordinate System Setting
Work Coordinate System
N160 M02
An over-cutting alarm is generated if you try to return to Point S directly from
Point 10. This is because the angle of 9-10-S is too sharp. The alarm is also
generated if the radius compensation is greater than 2.0 mm, which is the distance
from 8 to 9.
3.28 Coordinate System
3.28.1 Local Coordinate System Setting , G52
Command Format:
G52 X__ Y__ Z__
Command Description:
If it is required to set another sub-coordinate system for the geometric shape of the
Workpiece being processed under previous Working Coordinate System (G54..G59),
then the said sub-coordinate system will be regarded as the Local Coordinate System.
G52 X0.0 Y0.0 Z0.0: Cancel Local Coordinate System
Fig. 3-82
To Next Page
Loading...