4 MCM Parameter Settings
4 - 1
4 MCM Parameters
4.1 MCM Parameters
The MCM parameter setting function allows the user to define the controller system
constants according to mechanical specifications and machining conditions.
These parameters are classified into two groups: basic parameters and MCM
parameters.
4.1.1 Basic Parameters
Quickly press the key twice to enter the parameter setting screen as shown
below:
Fig 4-1
4.1.2 MCM Parameters
The correct and proper setting of these parameters is important for operation of the
mechanical system and fabrication of the work-piece. Make sure that the setting is
correct. Press to restart the machine when the MCM parameter is successfully
set
After pressing “F5-System Parameter” key in “User Parameter” page, the System
Parameter page can be accessed; but it can be reviewed and cannot be revised, as
per the figure below. To revise the system parameters, press “F7-Revise
Parameter” key and then input system parameter password initial value 123456
I/O
MCM
Reset
To Next Page
Loading...