HUST CNC H6D-T - Page 197

4 MCM Parameter Settings
4 - 21
71. Setting of rotation direction of spindle for search of RI point
Format  default value: 
Setting  , Positive rotating direction
Setting  1, egative rotating direction
Use this parameter to set the rotation direction of motor for search of RI point
encoder signal in -phase.
72. Setting of spindle rpm for search of RI point
Format  default value: 1, unit: RPM
Use this parameter to set rotation speed of motor for search of RI point
encoder signal in -phase
73. Setting of spindle orientation
Format  default value: 
Setting  , Positive rotating direction for spindle orientation
Setting  1, egative rotating direction for spindle orientation
Use this parameter to set the rotating direction for spindle orientation in manual
mode.
74. Setting of rotation speed of spindle orientation
Format  default value: 1, Unit: RPM
Use this parameter to set rotation speed for spindle orientation in manual mode.
75. Set if to find the Spindle OM signal
Format default value: .
Setting  : Quit finding Spindle OM Switch signal
Setting  1: Find Spindle OM Switch signal
signal of the Spindle is reuired. In this case, please install the ternal OM
Switch.
76. Set to find the speed of Spindle OM signal
Format
Set the RPM of Spindle when finding the eternal OM Switch.